Installation of the monument on your own is a difficult matter. However, this statement is true only if the person is not familiar with the procedure. So a monument made of polymer granite (polygran) can be installed in two ways. The first way is simpler, but it consists in using the services of masters to erect monuments. But this method will cost more. The second way is to install the monument manually. We will analyze it.
Instruction manual
1
At the site of the proposed flower garden, move the earth to the side, level the site. Then lay the flower bed on the ground, leaving an imprint.
2
Lift the flower garden and prepare two iron rods (reinforcement with a diameter of 14-19 mm and a length of 1.2-1.4 m). Lay the rods on the ground parallel to each other so that the distance between them is 80 cm.The fittings should lie at the place of installation of the flower garden, so that from its proposed edges to the axis of the armature there should be about 15 cm.Then install the flower garden on the armature, and then set it to level.
3
Fill the flower bed with earth and tamp on all the cavities. Drive two reinforcing bars with a diameter of 18 mm and a length of 1 m into the ground through the holes available in the upper part of the cabinet. When driving the rods, leave an allowance of 15-20 cm above the stand.
4
Now prepare a bucket of sand and cement, taking them in a ratio of 6: 1. Add water as you wish. Now fill the cabinet with this solution, sticking it through the holes in the cabinet. Now you need to prepare a solution already for the obelisk. You will need two buckets of a similar solution. It should be sufficiently plastic.
5
Turn the obelisk over, throwing the solution there. Close the opening of the obelisk with a film of polyethylene, and round its edges and fasten it on tape with tape. So when installing the obelisk, the solution will not fall out. Next, carefully turn the obelisk over and place it on the pedestal, fitting the pins protruding from the pedestal directly through the plastic film. Then slightly lift the obelisk, remove the film, then align it in the center and pat on the flat sides so that the solution compresses the fittings, falling down.
6
Now connect the solution from the obelisk with the solution in the cabinet to form a single unit. It remains only to wipe the edges of the monument from the solution using a rag or soft cloth.
